Setting Up DeWALT SITELOCK™

Step 1: Turn on the Base Unit

• Place unit 3 to 6 feet off the floor. It is recommended to use a mounting bracket (optional accessory DS001 sold separately)
• Avoid placing unit in direct sunlight or near heat sources
• Place unit in area with minimal vibration

Plug the power supply cord connector into unit

Plug the other end of power supply cord into wall outlet

Plug in one end of phone line into unto unit

Plug in other end of phone line into wall

Step 2: System Set-up

2a: Programming Base Unit (A) After base unit is connected, use the keypad and LCD screen to begin the initial setup sequence. (B) Check that the power LED is lit. STEPS OF THE SETUP PROCESS (1) Choose a language. (2) Set time and date. (3) Set master code (4) Assign devices (Step 2b). (5) Install devices and test range (step 2c). (6) Add users. (7) Activate service (Step 3).

2b: Assign Devices Refer to DS100 Instruction Manual for further details. (1) Open the housing by inserting a flat screwdriver into slot. (2) Insert battery. (3) Press the Reset Button when prompted by the Base Unit. OTHER DEVICES After programming the Key Chain Remote, continue programming other devices. Refer to individual sensor instructions for inserting battery and resetting sensor.

2c: Install Devices & Test Range

Before testing sensors, place them in the desired location. When asked to perform a walk test, select YES and then walk the site tripping each sensor until none remain on the list. Reference the instructions manual for each sensor for specific mounting instructions and recommended locations.

Step 3: Activate Service

	(1)	Contact customer service to register and activate your system at: Required Information:
		a.	Mobile Identification Number (MIN):
		b.	Account Number
		c.	Complete sensor location list
		d.	Billing information/contact information
		NOTE: The MIN and the account number will be provided during step 2, programming base unit (#7)
	(2)	Select service agreement plan.
	(3)	Perform a system test.
	(4)	Receive written confirmation from customer service on the user information and contract plan, sign contract and send back to customer service
	(5)	If you do not receive written confirmation after the activation process, contact customer service.

Step 4: Arming & Disarming